Difference between revisions of "IPv6 AutoConfiguration: Stateless auto-configuration"
Jump to navigation
Jump to search
Onnowpurbo (talk | contribs) (New page: 16.1. Stateless auto-configuration Is supported and seen on the assigned link-local address after an IPv6-enabled interface is up. Example: # ip -6 addr show dev eth0 scope link 2: eth0...) |
Onnowpurbo (talk | contribs) |
||
| Line 5: | Line 5: | ||
Example: | Example: | ||
| − | # ip -6 addr show dev eth0 scope link | + | # ip -6 addr show dev eth0 scope link |
| − | 2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qlen1000 | + | |
| − | + | 2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qlen1000 | |
| − | + | inet6 fe80::211:d8ff:fe6b:f0f5/64 scope link | |
| + | valid_lft forever preferred_lft forever | ||
Revision as of 13:46, 27 June 2013
16.1. Stateless auto-configuration
Is supported and seen on the assigned link-local address after an IPv6-enabled interface is up.
Example:
# ip -6 addr show dev eth0 scope link
2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qlen1000
inet6 fe80::211:d8ff:fe6b:f0f5/64 scope link
valid_lft forever preferred_lft forever