OpenWRT: Setup OLSR Sederhana

Setup Wireless MESH

Melalui Web

Administration > Network > Wifi > Scan

Klik pada jaringan MESH yang ada.

Setup Wireless IP Address Statik

Melalui Web

Administration > Network > Interfaces > Klik wireless interface

General Setup > Protocol > Static Address > IPv4 address > 10.x.x.x

General Setup > Protocol > Static Address > IPv4 netmask > 255.0.0.0

Pastikan IP address yang digunakan berbeda dengan teman-teman yang lain agar tidak tabrakan.

Setup Firewall untuk jadi gateway

Jika di perlukan agar proxy / NAT ke Internet bisa beroperasi dengan baik.

Melalui Web

Administation > Network > Firewall

Klik pada zone wireless

Advanced Setting > destination zones > klik WAN 

Setup OLSR menggunakan shell

Edit

vi /etc/olsrd.conf

Masukan

Hna4
{
#  192.168.0.0 255.255.255.0  - gateway ke 192.168.0.0/24
#  0.0.0.0 0.0.0.0            - gateway ke internet
}                                                                                

Hna6                                                                             
{                                                    
}

LoadPlugin "olsrd_nameservice.so.0.3"
{
}

LoadPlugin "olsrd_txtinfo.so.0.1"                                                
{                                                                                                 
    PlParam      "accept" "0.0.0.0"                                              
} 

InterfaceDefaults  
{                                                                                                      
}

Interface "wlan0"                                                 
{
     Mode "mesh"                                                                  
}

Edit

vi /etc/rc.local

Masukan

/etc/init.d/olsrd stop
olsrd -f /etc/olsrd.conf &

Pranala Menarik

• OpenWRT
• OpenWRT: Download Firmware yang sudah jadi
• OpenWRT: Source Repository Download
• OpenWRT: Melihat Daftar Package

Build Firmware

• OpenWRT: Build Firmware
• OpenWRT: Build Firmware Buffalo WZRHPG450H
• OpenWRT: Build Firmware Buffalo WZRHPG300N
• Buffalo
• Buffalo: WZRHPG450H Cara Recovery
• Buffalo: WZRHPG450H OpenWRT mengaktifkan setelah di flash
• Buffalo: WZRHPG450H Membuat Firmware OpenWRT Sendiri COOL
• Buffalo: WZRHPG450H OpenWRT instalasi aplikasi Pendukung OLSRD
• OpenWRT: Build Firmware Ubiquiti NanoStation2
• OpenWRT: Build Firmware Mikrotik RB433
• OpenWRT: Build Firmware Linksys WRT160NL
• OpenWRT: Build Firmware Linksys WRT54GL

Flash Firmware

• OpenWRT: Flash Linksys WRT54GL
• OpenWRT: Flash Linksys WRT160NL
• OpenWRT: Flash Buffalo WZRHP450H
• OpenWRT: Flash Buffalo WZRHP300N
• OpenWRT: Flash UBNT NanoStation2
• OpenWRT: Flash UBNT NanoStation M2
• OpenWRT: Flash UBNT NanoStation Loco M2

Misc

• OpenWRT: Setup OLSR di UBNT via CLI
• OpenWRT: Mikrotik RB433
• OpenWRT: Setup OLSR Sederhana
• OLSR - di OpenWRT
• OpenWRT: 3G modem
• OpenWRT: Build Firmware dengan 3G Modem Support
• OpenWRT: Setup Firewall
• OpenWRT: Konfigurasi UBNT NanoStation2 tanpa WebGUI

UBNT

• UBNT
• UBNT: Teknik Recovery
• UBNT: Upload Firmware
• UBNT: Rebuild Firmware
• UBNT: firmware dengan OLSR
• UBNT: openwrt
• UBNT: olsr dengan openwrt
• UBNT: olsr dengan kamikaze openwrt
• UBNT: olsr dengan backfire openwrt RECOMMENDED
• UBNT: UniFi
• UBNT: UniFi Konfigurasi Awal
• UBNT: UniFi Manajemen HotSpot
• UBNT: OLSR Pembuatan Firmware
• UBNT: OLSR Konfigurasi
• OLSR - di UBNT
• OLSR - di Ubuntu
• OpenWRT